Convertibars Honda: VFR-750 User Manual download pdf

Honda VFR-750

Bike Specific Install Notes and Tips

This is an aftermarket product that fits up different than the stock components, therefore, the installer may be required to

set up components and to route lines in the ?best way possible?, which may not always be listed on this ?Bike

Specific? installation sheet. In any case, the installation must allow the handlebars to reach both steering stops, with

out pulling taught or kinking any lines, and without damaging any part of the motorcycle

Important Installation Considerations

Stock throttle lines are ok rerouted but longer throttle lines are avaliable if

desired.

Special Kit Requirements/Installation Tips

1. Contact - Slight fairing contact is ok as long as the steering stops can be

reached with out damaging the fairing

2. Zip ties or brackets holding excess electrical lines will need to be cut or removed

to free up extra length.

Handlebar Positioning

1. When the bars are in the up position, with the wheel straight, the clamps should

be rotated so the handlebar risers are at approximately the 7 and 5 - O'Clock

positions(as the rider is looking down at the top of the fork tubes) This will allow

clearance with the upper fairing and windshield as you turn stop to stop.

Line Routing

1. Throttle Lines - Stock length - route behind the right fork tube

2. Electrical Lines to be freed from their brackets and or Zip Ties, and run on the

rider's side of the forks

3. Clutch Line - Free line from bracket and routed for best length

Recommended Riser Trim Length

1. 5.5" Riser Length = Trim Number 9

1 2

Honda VFR-750 Bike Specific Install Notes and TipsThis is an aftermarket product that fits up different than the stock components, therefore, the ins

Page 2

No comments

Convertibars Honda: VFR-750 User Manual